| 1 |
|
|---|
| 2 | Sun xVM VirtualBox for OpenSolaris (TM) Operating System
|
|---|
| 3 | --------------------------------------------------------
|
|---|
| 4 |
|
|---|
| 5 | Upgrading:
|
|---|
| 6 | ----------
|
|---|
| 7 |
|
|---|
| 8 | If you have an existing VirtualBox installation and you are upgrading to a newer version of
|
|---|
| 9 | VirtualBox, please uninstall the previous version completely before installing a newer one.
|
|---|
| 10 |
|
|---|
| 11 | You should uninstall BOTH the VirtualBox base package as well as the VirtualBox kernel
|
|---|
| 12 | interface package before installing the new ones.
|
|---|
| 13 |
|
|---|
| 14 | Please refer to the "Uninstallation" section at the end of this document for the details.
|
|---|
| 15 |
|
|---|
| 16 |
|
|---|
| 17 | Installing:
|
|---|
| 18 | -----------
|
|---|
| 19 |
|
|---|
| 20 | * Important Note:
|
|---|
| 21 | You must boot OpenSolaris in the same instruction set as the VirtualBox install package.
|
|---|
| 22 | This means if you are installing the 64-bit version of VirtualBox you MUST boot in
|
|---|
| 23 | 64-bit mode. This is because the installer will setup the VirtualBox driver. Use the command
|
|---|
| 24 | "isainfo -k" to check what instruction set is currently being used. If the output is "amd64"
|
|---|
| 25 | you have booted in 64-bit mode, otherwise it is 32-bit.
|
|---|
| 26 |
|
|---|
| 27 | After extracting the contents of the tar.gz file perform the following steps:
|
|---|
| 28 |
|
|---|
| 29 | 1. Login as root using the "su" command.
|
|---|
| 30 |
|
|---|
| 31 | 2. Install the packages (in this order):
|
|---|
| 32 | Newer versions of OpenSolaris may contain a vbi module. If your version does NOT have the
|
|---|
| 33 | vbi module already installed (check for existence of /platform/i86pc/kernel/misc/vbi)
|
|---|
| 34 | then run:
|
|---|
| 35 |
|
|---|
| 36 | pkgadd -G -d VirtualBoxKern-@VBOX_VERSION_STRING@-SunOS-r@[email protected]
|
|---|
| 37 |
|
|---|
| 38 | To perform an unattended (non-interactive) installation of this package add
|
|---|
| 39 | "-n -a autoresponse SUNWvboxkern" (without quotes) to the end of the above pkgadd command.
|
|---|
| 40 |
|
|---|
| 41 | Once the vbi module is installed run:
|
|---|
| 42 |
|
|---|
| 43 | pkgadd -d VirtualBox-@VBOX_VERSION_STRING@-SunOS-@BUILD_TARGET_ARCH@-r@[email protected]
|
|---|
| 44 |
|
|---|
| 45 | To perform an unattended (non-interactive) installation of this package add
|
|---|
| 46 | "-n -a autoresponse SUNWvbox" (without quotes) to the end of the above pkgadd command.
|
|---|
| 47 |
|
|---|
| 48 | 3. For each package the installer would ask you to "Select package(s) you wish to process"
|
|---|
| 49 | For this type "1" or "all".
|
|---|
| 50 |
|
|---|
| 51 | 4. Then type "y" when asked about continuing with the installation.
|
|---|
| 52 |
|
|---|
| 53 | Now all the necessary files would be installed on your system. Start VirtualBox by typing
|
|---|
| 54 | VirtualBox from the terminal.
|
|---|
| 55 |
|
|---|
| 56 |
|
|---|
| 57 | Uninstalling:
|
|---|
| 58 | -------------
|
|---|
| 59 |
|
|---|
| 60 | To remove VirtualBox from your system perform the following steps:
|
|---|
| 61 |
|
|---|
| 62 | 1. Login as root using the "su" command.
|
|---|
| 63 |
|
|---|
| 64 | 2. Run the command:
|
|---|
| 65 | pkgrm SUNWvbox
|
|---|
| 66 |
|
|---|
| 67 | To remove the VirtualBox kernel interface module run the command:
|
|---|
| 68 | pkgrm SUNWvboxkern
|
|---|
| 69 |
|
|---|
