%all.entities; ]> $Date: 2023-04-21 21:59:02 +0000 (Fri, 21 Apr 2023) $ VBoxManage-createvm 1 VBoxManage-createvm create a new virtual machine &product-name; VBoxManage createvm --name=name --basefolder=basefolder --default --group=group-ID, --ostype=ostype --register --uuid=uuid --cipher=cipher --password-id=password-id --password=file The VBoxManage createvm command creates a new XML virtual machine (VM) definition file. You must specify the name of the VM by using --name name. This name is used by default as the name of the settings file that has the .vbox extension and the machine folder, which is a subfolder of the $HOME/VirtualBox VMs directory. The actual file name may not correspond directly to the VM name if it violates the host OS file name requirements (such as using the path separator or other reserved characters, they will be substituted with a placeholder). If you later rename the VM, the file and folder names will be updated to match the new name automatically. In addition to specifying the name or UUID of the VM, which is required, you can specify any of the following options: --basefolder=basefolder Specifies the name of the folder in which to save the machine configuration file for the new VM. Note that the names of the file and the folder do not change if you rename the VM. --default Applies a default hardware configuration for the specified guest OS. By default, the VM is created with minimal hardware. --group=group-ID[,...] Assigns the VM to the specified groups. If you specify more than one group, separate each group name with a comma. Note that each group is identified by a group ID that starts with a slash character (/) so that groups can be nested. By default, a VM is always assigned membership to the / group. --ostype=ostype Specifies the guest OS to run in the VM. Run the VBoxManage list ostypes command to see the available OS types. --register Registers the VM with your &product-name; installation. By default, the VBoxManage createvm command creates only the XML configuration for the VM but does not register the VM. If you do not register the VM at creation, you can run the VBoxManage registervm command after you create the VM. --uuid=uuid Specifies the Universally Unique Identifier (UUID) of the VM. Ensure that this UUID is unique within the &product-name; namespace of the host or of its VM group memberships if you decide to register the VM. By default, &product-name; provides the UUID. --cipher=cipher Specifies the cipher to use for encryption. Valid values are AES-128 or AES-256. This option enables you to set up encryption on VM. --password-id=password-id Specifies a new password identifier that is used for correct identification when supplying multiple passwords for the VM. This option enables you to set up encryption on VM. --password=file Use the --password to supply the encryption password of the VM. Either specify the absolute pathname of a password file on the host operating system, or - to prompt you for the password on the command line. This option enables you to set up encryption on VM. The following command creates a VM called vm2 where you plan to run a 64-bit version of Oracle Linux. $ VBoxManage createvm --name "vm2" --ostype "Oracle_64" The following command creates and registers a VM called vm3. $ VBoxManage createvm --name "vm3" --register ,